[unixODBC-support] Make Problem

Nick Gorham nick.gorham at easysoft.com
Fri Jun 30 09:28:46 BST 2006


Freddy wrote:

> Hi Everyone.
>
> I am trying to Install unixODBC on a RedHat linux box.
>
> I run the ./configure command...
> All appears to run through fine except it gives the following message:
>
> "checking for X... configure: error: Can't find X includes. Please 
> check your installation and add the correct paths or run configure 
> with --enable-gui=no!"
>
> Am i correct in understanding that if this error is presented then the 
> ./configure command stops?
>
> As this is my first foray into Redhat and unixODBC, could anyone 
> suggest the ./configure command and switches that I should use?
>
> Any help very much appreciated.
> Thanks
> Freddy
>
err, as the message you copied said. "run configure with --enable-gui=no".

./ configure --enable-gui=no

should do it.

-- 
Nick Gorham
Easysoft Limited
http://www.easysoft.com, http://www.unixODBC.org




More information about the unixODBC-support mailing list